Taking the mobile lifting basketball stand as an example, the installation steps are:

Connect the wheel pin bottom main rod

Pass the wheel pin through the hole under the base and connect the wheel and bottom rod pin in turn.

Connect tie rod

Use a pair of tie rods to connect and reinforce the bottom rod and the base, and fix the joints tightly with screws. It should be noted that the tie rods are divided into left and right.

Connect the middle pole

Insert the middle pole above the low pole and secure it tightly with screws. Connect the backboard to the basketball hoop with the ring in front, the backboard in the back, and the backboard in the middle. Align the four holes and tighten them with screws.

Install the Nets

The 12-button basket net snaps into the buckle slot and goes in with a slight pull, and is installed in sequence.

Connect up and down

Connect the completed part of the top to the middle pole. The upper pole has multiple holes, and you can install it at the appropriate height according to your needs.

Add water and sand weight

After installation is completed, water or sand must be added to the base for weighting.